ISO 4156-1_圆柱直齿渐开线花键中文翻译版201306.docx

PAGE \* MERGEFORMAT ii INTERNATIONAL ISO STANDARD 4156-1 国际标准 ISO 4156-1 First edition 第一版次 2005-10-01 Straight cylindrical involute splines— 圆柱直齿渐开线花键 Metric module, side fit — 米制模数 齿侧配合 Part 1: 第一部分 Generalities 总论 Cannelures cylindriques droites à flancs en développante — Module métrique, à centrage sur flancs — Partie 1: Généralités Refere Reference number ISO 4156-1:2005(E) ? ISO 2005 PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. PDF免责申明 此PDF文档包含了几种嵌入字体。根据Adobe的许可条款，此文档可以打印或浏览；但若这几种嵌入字体未被允许使用或安装在可编辑的计算机上，此文档不可被编辑。当事人若下载此文档，应接受其中的责任，不得违反Adobe的许可条款。ISO中央秘书处不承当此范围的责任。 Adobe是Adobe Systems公司的注册商标。 用于创建PDF文件的软件细节部分，可以在总信息中找到； PDF创建参数已经被优化过以便于打印。所有（使用此文档时）可能出现的问题都已经考虑过，以便不同的ISO成员国使用此文档。如果此版本文档出现意外情况，请按下列方式告知ISO中央秘书处。 译注A1：凡是带“译注XX”的，都表示翻译者的理解。 译注A2：《GB/T 3478.1-2008 圆柱直齿渐开线花键》（以下简称《GB 3478.1》） ? ISO 2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or