台安变频器(TAIAN)N310-EN说明书_1-111.doc

Microprocessor Controlled I G B T Drive Inverter Motor Speed Regulator Operating Manual N310 Serise 200V class 0.4~2.2KW (1.2~4.0KVA) 400V class 0.75~55KW (1.7~110KVA) Quick Start Guide This guide is to assist in installing and running the inverter to verify that the drive and motor are working properly. Starting, stopping and speed control will be from the keypad. If your application requires external control or special system programming, consult the N310 Instruction Manual supplied with your inverter. Step 1 Before Starting the Inverter Please review Preface and Safety Precautions (1 through 1- 3) of the N310 Instruction Manual. Verify drive was installed in accordance with the procedures as described in N310 Ambient Environment and Installation on pages 3-1 through 3-8. If you feel this was abnormal, do not start the drive until qualified personnel have corrected the situation. (Failure to do so could result in serious injury.) Check inverter and motor nameplates to determine that they have the same HP and voltage ratings. (Ensure that full load motor amps do not exceed that of the inverter.) Remove the terminal cover to expose the motor and power terminals. Verify that AC power is wired to L1, L2, and L3 (pages 3-12). Verify that Motor leads are connected to T1, T2, and T3 (pages 3-12). (The two leads may need to be reversed if motor rotation is not correct. Four action of FUN, Hz/RPM, VOLT, AMP LED and display of five 7-segment displays, refer to operation description of the keypad. SEQ LED: 00-03(or 00-04) =1/2/3, LED Lit. FRQ LED: 00-05(or 00-06) = 1/2/3/4, LED Lit FWD LED: Forward Direction, LED action (Flash in stop, Keep Lit in operation). REV LED: Reverse Direction, LED action (Flash in stop, Keep Lit in operation). iv Step 2 Apply Power to the Drive Apply AC power to the Drive and observe Operator. Five 7-segment Display should read Power Voltage for 2 seconds and then read Frequency/Speed, 5.00. Five 7-segment Display and FWD LED should be flashed al