德国伏科控制器 Phocos英文版本.doc

MPPT 100/30 Maximum Power Point Tracker Maximum Power Point Tracking Technology increases the efficiency of your PV system Less expensive solar-panels for grid-feed-in systems can now be used for 12/24V off-grid systems Electronic protection (reverse polarity, over-current, short-circuit, over-temperature) High efficiency DIN Rail compatible Negative grounding With innovative maximum-power-tracking technology, Phocos MPP-Tracker ensures maximum performance from your solar array at all times and in all weather conditions. The MPPT can yield an energy gain of up to 30% from your PV array (with the average gain being 10%-25%). When a Central Unit is used, up to 16 MPPTs can be used together in one system. The charge regulation is then done via data bus by the Central Unit. This will enable you to increase your system capacity substantially. The temperature-compensated three-stage I-U curve charge regulation alogarithm significantly extends the lifespan of your battery.The possibility to use less expensive grid-feed-in solar-panels with up to 95V open circuit voltage for 12V or 24V stand-alone systems will significantly reduce the cost of the total system. TYPE MPPT 100/30 Nominal Voltage 12V/24V,automatic recognition Nominal battery charge current 30A Max. Solar Input Voltage Voc 95V Max. PV Input Power 450W@12V, 900W@24V Max. Battery Charge Current 33A Power Conversion Efficiency over 98 % Standby Power Consumption 30mW at 12V system voltage ( 2mA)  80mW at 24V system voltage ( 3mA) Temperature compensation -4 mV/cell*K Max. wire size 32mm2 Dimensions 185 x 150 x 115mm Weight 1.6kg Temperature range -40 to +50 °C Type of protection IP22 CX10, CX20, CX40 Solar Charge Controller with LCD Display Battery State-of-Charge display LCD Charge and discharge status display Acoustic load disconnect pre-warning Load status indication Choose between 5 load disconnect algorithms boost/absorption/float PWM-regulation (series type) Integrated temp