PCB钻孔机-CNC84 数控操作系统SEIB & MEYER控制器操作手册.docx

SIEB & MEYER WCNC 8x.00InstallationThe CNC controller software setup P-TD-0000175.72013-01-04CopyrightCopyright ? 2013 SIEB & MEYER AG.All rights reserved.This manual or extracts thereof may only be copied with the explicit authorization of SIEB & MEYER AG.TrademarksAll product, font and company names mentioned in this manual may be trademarks or registered trademarks of their respective companies.SIEB & MEYER worldwideFor questions regarding our products and technical problems please contact us.SIEB & MEYER AGAuf dem Schmaarkamp 21D 21339 Lüneburg GermanyPhone: +49 4131 203 0 Fax: +49 4131 203 2000 support@sieb-meyer.de /SIEB & MEYER Shenzhen Trading Co. Ltd.1st floor, B room of D1 block, DongNan GongMao BuildingDongjiaotou Shekou, Houhai Ave, Nanshan DistrictShenzhen City, 518067P.R. ChinaPhone: +86 755 2681 1417 / +86 755 2681 2487 Fax: +86 755 2681 2967 sma-china@ /SIEB & MEYER Asia Co. Ltd.4 Fl, No. 532, Sec. 1Min-Sheng N. RoadKwei-Shan Hsiang333 Tao-Yuan Hsien TaiwanPhone: +886 3 311 5560Fax: +886 3 322 1224SIEB & MEYER USA, LLC3975 Port Union RoadFairfield, OH 45014 USAPhone: +1 513 563 0860 Fax: +1 513 563 7576 info@ /smasia@ /Content1 About this Manual51.1 Illustration of General Notices52 Introduction73 The Installation Wizard93.1 Start Page (Welcome)93.2 Installation Mode93.3 Language Selection123.4 Links133.5 Installation Steps144 Downgrade194.1 Downgrade from Version 11.02.001194.2 Downgrade from Version 11.07.002205 Appendix235.A Flash Disc Installation with Write-Protection23Removing Windows Warnings23ContentAbout this ManualAbout this Manual1This chapter explains symbols, signal words and abbreviations possibly used in this manual.Illustration of General NoticesGeneral notices are illustrated by the following symbols:SymbolDescriptionHint with additional, further informationTip with suggestions and useful informationAbout this Manual1IntroductionIntroductionThis manual describes the software installation for the controllers of series CNC 84.00 and C