水压试验及冲洗程序.docx

Procedure for Hydrostatic Testing and Flushing of Procedure for Hydrostatic Testing and Flushing of Piping 管线水压试验及冲洗程序 Plant: Client: PP+HDPE CSPC contractor: TCM Subcontractor: CP6CC 编号 Ref.No: NH- HDPE+PP- WPR-211 REV：B Page 1 of 10 CONTENT 目录 Scope 范围 Reference 参考文件 Personnel Safety 人身安全 General Requirements 一般要求 Record 记录 Revision 修订 Procedure for Hydrostatic Testing and Flushing of Procedure for Hydrostatic Testing and Flushing of Piping 管线水压试验及冲洗程序 Plant: Client: PP+HDPE CSPC contractor: TCM Subcontractor: CP6CC 编号 Ref.No: NH- HDPE+PP- WPR-211 REV：B Page 1 of 10 Scope 范围 This work details the method of hydrotesting for the CSPC Nanhai Petrochemical Project HDPE/PP Pipes above /under ground to be tested. 本程序叙述了南海石化项目HDPE+PP 装置管线系统进行水压试验及冲洗的一般要求。该试验程序适用于所有地上和地下管线的试验和冲洗。 References 参考文件 NH-HDPE+PP-WPR-208 PREFAB.ERECTION PROCEDURE FOR PROCESS PIPING 工艺管线施工程序 2.2 PR-8710-0000-0067-CSPC 管道工程试压试漏 PR-8130-0000-0007-CSPC FLUSHING AND BLOWING OF LINES AND EQUIPMENT 管道和设备的冲洗与吹扫 ASME B31.3 Process pipeline 工艺管道 Personnel Safety 人生安全 Personnel Safety refer to the section 14 of PROCEDURE FOR PROCESS PIPING CONSTRUCTION- NH-HDPE+PP-WPR-208. 人生安全要求见“工艺管线施工程序”，文件号为 NH-HDPE+PP-WPR-208 中第 14 节。 General Requirements 一般要求 This procedure applies to a range of different type of tests for different combinations of assemblies and pipe. 本程序适用于对组件与管子的不同组合所进行的各种不同类型的水压试验及冲洗要求。 Notice to TCM 通知 TCM Notice of inspection shall be given to TCM prior to cleaning/gauging, filling, Hydrotesting and dewatering the pipe. 在对管路进行清洗、水压试验之前，应将检验通知送达 TCM 工程师。 Procedure for Hydrostatic Testing and Flushing of Procedure for Hydrostatic Testing and Flushing of Piping 管线水压试验及冲洗程序 Plant: Client: PP+HDPE CSPC contractor: TCM Subcontractor: CP6CC 编号 Ref.No: NH- HDPE+PP- WPR-211 REV：B Page 1 of 10 Water sources and filling 水源与充水 Mainline pipe sections (gathering lines) will be filled from an approved water source. Samples of water will be analyzed and the resulting report will be reviewed by QC departmen