me主机培训-上课concept.pptx

ME Engines Training Course--ME Concept;ME ENGINE CONTROL SYSTEM（ECS）;ME ENGINE CONTROL SYSTEM（ECS）;;;;多功能控制器 Multi Purpose Controller （MPC）;MPC的信息代码;MPC的LED信息代码;MPC10 –专用于CCU ;Dismantling of MPC board;5. Dismount the screws retaining the MPC board and remove it from the panel. Dismantling of Amplifier In the CCU and ACU panels amplifiers are mounted below the MPC board. 6. Unplug the power connector from the bottom of the MPC board. 7. Unplug the two connectors on the amplifier.;If a spare MPC board has been used previously on another engine it is necessary to force the MPC to update software from the MOP panel. This is done in the following way: Set the yellow dip switch No. 4 on the side of the replacement MPC to OFF. Mount the MPC as described. Power on the MPC and let the MPC finish downloading. When the MPC LED flashes 2 red and 3 green, set the yellow dip switch No. 4 to ON. ;Changing the battery of the MPC may cause a reset and restart of the MPC. Therefore, only change the battery while: ? the ship is in harbour with engine stopped, or ? when sailing in unrestricted areas, where a restart of an MPC does not imply any risk for the ship or the engine. The battery only serves as backup supply for the built-in clock of the MPC, and low battery level for several days until entering port is of no consequence to the safe operation of the engine.;3. Check that the coloured DIP switches 1 and 8 on the side of the MPC board are set to the “off” position. 4. Mount the MPC board in the panel. 5. Mount the connectors according to the table shown on the metal plate on the MPC board.;6. Mount the ID-key. 7. Mount the power connector. 8. During the start up process, the LED will flash and the MPC board will reboot several times. During start up, the MPC verifies if the